Fork Support
Travel adjustment must be performed internally. Instructions for this procedure can be found within the Helm instruction manual included with every fork. It...
Wed, 1 Apr, 2026 at 3:09 PM
Helm forks are only available in 15mmx110mm BOOST spacing with traditional end caps.
Wed, 1 Apr, 2026 at 3:10 PM
No, Helm’s D-Loc axle must be used on Helm forks, using any other axle system will void its warranty.
Wed, 1 Apr, 2026 at 3:11 PM
Because the two air chambers are isolated, the rider can set different air pressures in the differing chambers for the desired feel. First, inflate the posi...
Wed, 1 Apr, 2026 at 3:13 PM
No, Invert Enduro comes with an air spring only. It’s a very adjustable air spring that can be setup to feel super plush and linear if you prefer that feeli...
Thu, 16 Apr, 2026 at 10:15 AM
Invert Enduro uses a closed-cartridge, monotube damper with a bladder. It’s the second generation Cane Creek fork damper and the same one used in Helm MKII....
Thu, 16 Apr, 2026 at 10:16 AM
Independent high and low speed compression, with a single low speed rebound adjuster. The high-speed rebound is pre-set and managed internally by a shim sta...
Thu, 16 Apr, 2026 at 10:17 AM
Progression for Invert Enduro is adjusted using a fully onboard volume adjustment system. It consists of a shaft and piston that live directly underneath th...
Thu, 16 Apr, 2026 at 10:17 AM
No. The Axle-to-Crown (fork height) of Invert Enduro is 586mm in the 170mm travel version. Simply add or subtract 10mm to determine ATC for the 160mm and 18...
Thu, 16 Apr, 2026 at 10:18 AM
Routine splash oil changes (typical ‘lowers service’) can easily be done in a matter of minutes at home. This procedure does not require special tools beyon...
Thu, 16 Apr, 2026 at 10:18 AM